Operating instructions

34
PROBLEMS CAUSES SOLUTIONS
The machine does not turn on. The machine is not connected to the
power source.
Connect the machine to the power source.
The plug has not been plugged into the
back of the machine.
Insert the plug into the machine’s power
socket.
Machine in stand-by. Press the brew button to start the machine.
Coffee is not hot enough. The cups are cold. Warm the cups with hot water.
Hot water or steam is not dispensed. The hole of the hot water wand is
clogged.
Clean the hole of the hot water wand using
a pin.
Coffee has little crema. The coffee blend is unsuitable or coffee
is not freshly roasted.
Change coffee blend.
The SBS dial is turned towards the left Turn the SBS dial to the right
The machine takes a long time to warm
up or the amount of water dispensed
from the wand is too little.
The machine’s water circuit is obstructed
by limescale build-up.
Descale the machine.
The brew group does not come out. The brew group is out of place. Turn the machine on. Close the service door.
The brew group is automatically placed in the
correct position.
Dregdrawer is inserted. Remove the dregdrawer fi rst, then the brew
group.
The machine grinds the coffee beans but
no coffee comes out.
(see note)
Water tank is empty. Fill the water tank and prime the water circuit
again.
Brew group is dirty. Clean the brew group.
Circuit is not primed. Prime the circuit again by dispensing water
from the hot water wand.
Rare event that occurs when the
machine is automatically adjusting the
dose.
Brew a few coffees as described in the
manual.
The coffee volume knob is turned to
the left.
Turn the knob clockwise.
The coffee is too weak.
(see note)
Rare event that occurs when the
machine is automatically adjusting the
dose.
Brew a few coffees as described in the
manual.
Coffee is brewed slowly.
(see note)
Coffee is too fi ne. Adjust the grinder to a coarse grind (see
page 15).
The water circuit is not primed. Prime the circuit again by dispensing water
from the hot water wand.
The brew group is dirty. Clean the brew group.
Coffee leaks out of the dispensing head. Dispensing head is clogged. Clean the dispensing holes with a soft cloth.
Brewing does not start. Coffee bean lid is not closed properly. Correctly place the lid on the coffee bean
hopper and press it fi rmly.
Note: If dealing with an initial start-up or if the coffee blend has been changed, a certain number of coffees must be
brewed in order to allow the machine to optimize the parameters.
Please contact Saeco or an authorized service center for any problems not covered in the above table or when the
suggested solutions do not solve the problem.
TROUBLESHOOTING