Service manual

SYNTIA CAPPUCCINO 03 USER INSTRUCTIONS
Saeco International Group Page / 05
02
Alarm indications (RED)
Indications Causes Solutions
Switch the appliance off and back on after 30
seconds. Repeat this twice or three times
If the appliance does not go on, contact the
Service Centre.
Problems with the water circuit. Press the
button to start the manual loading
cycle of the water circuit
Wait for the circuit to ll up
No coffee beans inside the container.
Restart the cycle after having lled the
coffee container
No water Fill the water tank
1
Warning indications (ORANGE)
Indications Causes Solutions
Appliance is in heating mode to
dispense coffee, hot water or steam
Wait for the heating process to end
(see the progress bar)
The appliance is in rinsing mode
wait for the appliance to complete the
operation
Wait for the operation to be completed
The machine requires a
descaling cycle
Perform a descaling cycle
Press the aroma/pre-ground coffee
button for 5 seconds to access the
descaling cycle
The brewing unit is in restart mode
for the appliance to be reset Wait for the restart to be complete
Fill the coffee bean container and
restart the dispensing cycle Fill the coffee bean container
The appliance requires the Intenza
lter to be replaced
Replace the lter. This message is
displayed if the function is activated
via the programme
The alarm is only disabled if “RESET” is
performed via the programme
The appliance requires the milk
system to be cleaned
After having washed the milk unit, press the
button to cancel the message
MENU
ESC
OK
+
ON
OFF
RESET
-
OK
CLEAN
START