Service manual

4/11
TALEA Section 07
REV00 - August 06
7.4 Gearmotor
Remove the safety guard (A)
by loosening the screws as
indicated.
Loosen the two screws indicated
and remove the heater pin. When
refitting it, be careful with the
two oil-rings shown in the smaller
picture.
Disassemble the pro
-
tection plate (B) by
loosening the screws as
indicated.
The following are fitted inside the compartment pro
-
tected by the guard:
- Electric motor (A) with gears (B) and (C) for
transmission and timing of the brew group.
- The drip tray presence reed switch
sensor (D).
- Brew group presence microswitch (E).
- Microswitch (F) which intercepts the rest
phase of the brew group.
- Microswitch (G) which intercepts the dis-
pense phase of the brew group.
Withdraw the gear (C) that meshes with the motor
transmission shaft.
Withdraw the large gear (B).
Pull out the motor (A) complete with transmission
shaft (H).
A
B
A
B
E
C
D
F
G
Insert the gear (B), taking care
that the arrow stamped on the
element is within the opening that
contains pin (P).
P
B
Install the motor and transmission shaft,
inserting the guides (L) in the relative seat.
L