User's Manual
Table Of Contents
- Chapter 1: OVERVIEW
- Chapter 2: INSTALLATION
- Chapter 3: WEB GUI
- Initial configuration
- Over The Air
- Networking
- Performance
- System
- FW ( Firmware upgrade
- Configuration ( IP configuration
- Configuration ( SNMP configuration
- Configuration ( Configuration file
- Configuration ( System configuration
- Diagnostic ( Loopback configuration
- Diagnostic ( Download troubleshooting file
- Tools ( License management
- Tools ( Console
- About ( About System
- About ( Copyright
- Chapter 4: INTERFACES
- CONTACTS
INTEGRA User Manual INSTALLATION
12
Chapter 2: INSTALLATION
Integra FODU: assembling mounting bracket and
installing with antenna on a pole
Disassembled mounting bracket and tools required for assembly
Parts of disassembled mounting bracket: 1 – three (3) M8x1.25x16 hex flange bolts
already attached to clamps for housing and pipe [7]; 2 – one (1) hex flange bolt M8x1.25x20;
3 – one (1) hex flange bolt M8x1.25x30, one (1) M10x1.5 hex flange nut and one (1) M8x80
eye screw already attached to clamps for housing and pipe [7]; 4 – one (1) M8x80 eye screw;
5 – two (2) M8x1.25 hex flange nuts already attached to M8x80 eye screw [3]; 6 – four (4)
M8x160 threaded rods; 7 – clamps for housing and pipe interconnected with three (3)
M8x1.25x16 hex flange bolts [1] and eye screw for horizontal alignment [3]; 8 – ten (10)
M8x1.25 hex flange nuts; 9 – two (2) mounting bracket clamps.
Parts of disassembled mounting bracket
Parts of Integra FODU: 10 – spacer hex flange nut; 11 – lifting eye nut; 12 – fixation
plate; 13 – side screw flange nuts; 14 – grounding flange nut.
Numbers of mounting bracket and Integra FODU parts in next sections will be mentioned in
square brackets [].
2
4
6
8
3
9
5
7
1
11
13
10
12
14
SAF Tehnika JSC