User's Manual

INTEGRA User Manual INSTALLATION
13
Changing polarization of Integra FODU and antenna
Tools required: 13mm (0.512”) wrench (comes in package)
1 Remove Integra FODU with antenna from
mounting bracket.
Default polarization is vertical.
2 Using 13mm wrench remove indicated nuts
and fixation plate [10, 11, 12, 13, 14].
3 Removed parts must be attached back with
90 degree offset (see above). Gap between
side screw flange nuts [13] and fastening
angles should be 5mm.
4 View of Integra FODU with swapped
polarization.
5 30 cm antenna: when polarization is
changed, make sure that drain hole cap
located at grounding flange nut should be
removed and inserted in previous drain hole.
6 60 cm antenna: make sure that one of two
water drain holes is aligned with Integra
FODU’s grounding flange nut.
SAF Tehnika JSC