User's Manual

INTEGRA User Manual INSTALLATION
16
For extra protection from sun radiation it is
recommended to install sun shield to cover the radio
Antenna alignment
Tools required: 13mm (0.512”) wrench (comes in package)
1
Before aligning the antenna, make sure that
screws marked with red dots on the right side
view of mounting bracket are loosened - hex
flange nuts and bolts of azimuth and elevation
eye screws, right side screw on Integra FODU
and hex flange bolt on azimuth angle indicator.
2
Additionally loosen following screws marked
with red dots on the left side view of mounting
bracket: left side screw on Integra FODU and
two hex flange bolts between both mounting
bracket clamps for housing and pipe.
3
For initial alignment make sure that elevation
is approximately at zero degree angle by
adjusting hex flange nuts [9] on vertical
alignment eye screw so that Integra’s housing
is parallel with the bracket.
4
Adjust azimuth angle by manually moving
mounting bracket in horizontal axis. Note that
all azimuth position fixing hex flange bolts [8],
as well as horizontal alignment eye screw with
flange bolt [3] need to be loosened ensuring
free movement in horizontal axis.
SAF Tehnika JSC