User's Manual
Table Of Contents
- Chapter 1: OVERVIEW
- Chapter 2: INSTALLATION
- Chapter 3: WEB GUI
- Initial configuration
- Over The Air
- Networking
- Performance
- System
- FW ( Firmware upgrade
- Configuration ( IP configuration
- Configuration ( SNMP configuration
- Configuration ( Configuration file
- Configuration ( System configuration
- Diagnostic ( Loopback configuration
- Diagnostic ( Download troubleshooting file
- Tools ( License management
- Tools ( Console
- About ( About System
- About ( Copyright
- Chapter 4: INTERFACES
- CONTACTS
INTEGRA User Manual INSTALLATION
18
1
Using size 5 allen wrench loosen one clamp
completely and second clamp by a half-turn.
2
Put Integra-S on antenna adapter flange by
hooking half-turn loosened clamp at the top
and leaving the completely loosened clamp
at the bottom. Make sure O-ring is in place
and the adapter flange fits into the Integra-S
transition flange socket.
Note! Protective sticker should be removed
before attaching the Integra-S FODU to the
antenna.
3
Secure the interconnection by tightening the
bottom clamp (not fully). Make sure rotation
of the Integra-S is still possible.
4
Rotate Integra-S to match the required
polarization.
5
The sticker on the back lid indicates the
polarization of the Integra-S. Adjust
polarization so that the interface ports are
located at the lower side of the Integra-S.
6
Verify polarization accuracy with a level, by
placing it against the top edge of the
Integra-S housing
SAF Tehnika JSC