User's Manual

INTEGRA User Manual WEB GUI
23
1
Tx power
Available range depends on radio model and selected modulation. Actual range will be
indicated in the brackets.
2
Tx frequency
Available range depends on frequency band, subband, radio side and channel bandwidth
selected. Actual range will be indicated in the brackets.
Tx frequency range indicates range of central frequencies for configured channel bandwidth.
Default frequency range (indicated on the label) is defined for 3.5MHz channel bandwidth.
3
Standard
Allows choosing whether only FCC, ETSI or both channel bandwidth options are visible in
“Configuration” selection field.
4
Bandwidth
Allows choosing between available channel bandwidth options along with indication of
maximum modulation, as well as according standard of channel bandwidth – ETSI or FCC.
5
Modulation
Allows choosing between available modulations for selected channel bandwidth.
“FEC” suffix indicates better sensitivity mode (longer FEC overhead), while “Weak FEC”
indicates higher capacity mode (shorter FEC overhead).
“Weak FEC” is available only for highest modulation for selected channel bandwidth.
6
State
Allows enabling/disabling each of three available LAN ports.
7
Execute
By pressing „Execute configuration” changes made to the corresponding section apply only
for the local side Integra. If „Rollback on” is selected, configuration will be reverted in case
erroneous configuration changes are applied.
Pressing „Execute for both” applies changes made to the corresponding section both for
local and remote side Integras.
SAF Tehnika JSC