User's Manual

INTEGRA User Manual WEB GUI
25
5) RSSI LED – allows disabling/enabling RSSI LED operation. By default RSSI LED is
enabled. Please refer to RSSI LED section
for further explanation;
6) RSSI LED mode – allows selecting RSSI LED operation mode. By default Mode 1 is
enabled. Please refer to RSSI LED section
for further explanation;
7) Standard – Allows choosing whether only FCC, ETSI or both channel bandwidth
options are visible in “Configuration” selection field.
8) Bandwidth – Allows choosing between available channel bandwidth options along
with indication of maximum modulation, as well as according standard of channel
bandwidth – ETSI or FCC.
9) Modulation – Allows choosing between available modulations for selected channel
bandwidth.
“FEC” suffix indicates better sensitivity mode (longer FEC overhead), while
“WeakFEC” indicates higher capacity mode (shorter FEC overhead).
“Weak FEC” is available only for highest modulation in selected channel bandwidth.
10) By pressing „Execute configuration” changes made to the corresponding section
apply only for the local side Integra. If „Rollback on” is selected, configuration will be
reverted in case erroneous configuration changes are applied.
Pressing „Execute for both” applies changes made to the corresponding section
both for local and remote side Integras.
CLI commands:
radio status
Use to show radio status.
radio power <Tx power>
Use to set Tx power in dBm.
radio frequency <frequency>
Use to set Tx frequency in kHz.
radio rssi-led <enable|disable>
Use to enables or disable RSSI LED operation.
radio tx-mute <time|disable>
Use to mute transmitter on specific time in seconds or
unmute.
radio factory
Use to reset radio settings to factory defaults – Tx power
will be disabled and frequencies set to factory defaults.
radio upgrade
Use to upgrade radio software version.
radio version
Use to check radio software version
radio show-counters
Use to show radio interface counters.
modem configuration set
<bandwidth> <min_mod>
<max_mod>
Use to set modem configuration – bandwidth, minimum
and maximum modulation. “_W” suffix indicates “Weak
FEC” modulation.
modem configuration set
factory
Use to reset modem settings to factory defaults –
bandwidth and modulation will be reset to minimum.
modem loopback <digital|none>
Use to enable or disables modem loopback.
modem performance
Use to check modem statistics according to ITU-T G.826.
Refer to description on Modem performance for further
explanation.
modem allowed
Use to check list of available modem configurations.
SAF Tehnika JSC