User's Manual

INTEGRA User Manual WEB GUI
26
Networking
Ethernet à VLAN
The VLAN configuration window provides configuration of port-based Ethernet Virtual
Local Area Networks (VLANs), allowing using up to 4095 different VLAN IDs. It is possible to
set VLAN IDs as tagged or untagged members on each LAN port.
In order to add VLAN tag to untagged packets on ingress direction, according “Default
VLAN” (2) should be specified. By default “Default VLAN” value on all ports is VLAN ID 1.
An example below shows sample configuration with VLAN IDs 100-300 configured as
tagged members on LAN2 and WAN ports (user traffic) and VLAN ID 500 as tagged member
on LAN2 and WAN ports, and untagged member on MNG port (management traffic).
1) VLAN state – enable or disable 802.1Q support;
2) Default VLAN – specify default VLAN ID on each of LAN and WAN ports – indicating
VLAN ID to be added to untagged packets entering particular port;
3) VID (1 .. 4094) – enter VLAN ID (or range) to be added;
4) TAGGED MEMBER – specify ports on which VLAN ID will be trunked;
5) UNTAGGED MEMBER – specify ports on which VLAN ID will be tagged/untagged
(access type);
6) MNG – specify which individual VLAN ID will be used for management access;
7) Add / Delete – Press “Add” to add entered individual VLAN ID or range of VLAN IDs
or press red cross (
×) to delete VLAN entry;
8) By pressing „Execute configuration” changes made to the corresponding section
apply only for the local side Integra. If „Rollback on” is selected, configuration will be
reverted in case erroneous configuration changes are applied.
SAF Tehnika JSC