User's Manual
Table Of Contents
- Chapter 1: OVERVIEW
- Chapter 2: INSTALLATION
- Chapter 3: WEB GUI
- Initial configuration
- Over The Air
- Networking
- Performance
- System
- FW ( Firmware upgrade
- Configuration ( IP configuration
- Configuration ( SNMP configuration
- Configuration ( Configuration file
- Configuration ( System configuration
- Diagnostic ( Loopback configuration
- Diagnostic ( Download troubleshooting file
- Tools ( License management
- Tools ( Console
- About ( About System
- About ( Copyright
- Chapter 4: INTERFACES
- CONTACTS
INTEGRA User Manual WEB GUI
29
network port <port> set mtu
<60..9600>
Use to change supported L2 frame size on particular
port. Default value is 9600 bytes.
network port <port> set speed
<auto|100fdx|100hdx|10fdx|10hdx>
Use to change speed and duplex setting on particular
port. Default value is “auto” (autonegotiation).
Synchronization à SyncE
Synchronous Ethernet (SyncE) allows synchronizing Ethernet switch clock to an external
source clock by specifying an ingress port.
Incorrect SyncE configuration may result in a loss of connectivity.
1) Port - Indicates SyncE source port (if enabled);
2) State – Indicates if SyncE is enabled;
3) Status – Indicates “Locked” if SyncE is operating normally;
4) Source port configuration – allows specifying SyncE source port;
5) Disable/Enable – Disable or Enable SyncE operation.
Configuration examples
1) Integra link with an external clock source
SAF Tehnika JSC