User's Manual
Table Of Contents
- Chapter 1: OVERVIEW
- Chapter 2: INSTALLATION
- Chapter 3: WEB GUI
- Initial configuration
- Over The Air
- Networking
- Performance
- System
- FW ( Firmware upgrade
- Configuration ( IP configuration
- Configuration ( SNMP configuration
- Configuration ( Configuration file
- Configuration ( System configuration
- Diagnostic ( Loopback configuration
- Diagnostic ( Download troubleshooting file
- Tools ( License management
- Tools ( Console
- About ( About System
- About ( Copyright
- Chapter 4: INTERFACES
- CONTACTS
INTEGRA User Manual WEB GUI
32
Performance
Alarm à Alarm status
Alarm status page summarizes current alarms by showing date and time the alarm
occurred and its name.
1) Date – shows date when alarm was initiated;
2) Time – shows time when alarm was initiated;
3) Alarm – shows name of the alarm.
Alarm à Alarm log
Alarm log shows 20 latest alarm entries per page and about 400 latest alarm entries in
total. Full alarm log can be downloaded by pressing on “Alarm event log file”. Last 20 log
entries are shown by default.
Alarm entries are mostly distributed in two groups – “Set”’ when alarm appears and
“Reset” when alarm disappears.
You also have fast access to alarm filtering, where it is possible to choose which alarm
groups you are willing to filter out of all log entries.
SAF Tehnika JSC