User's Manual
Table Of Contents
- Chapter 1: OVERVIEW
- Chapter 2: INSTALLATION
- Chapter 3: WEB GUI
- Initial configuration
- Over The Air
- Networking
- Performance
- System
- FW ( Firmware upgrade
- Configuration ( IP configuration
- Configuration ( SNMP configuration
- Configuration ( Configuration file
- Configuration ( System configuration
- Diagnostic ( Loopback configuration
- Diagnostic ( Download troubleshooting file
- Tools ( License management
- Tools ( Console
- About ( About System
- About ( Copyright
- Chapter 4: INTERFACES
- CONTACTS
INTEGRA User Manual WEB GUI
33
1) Clear alarm log – deletes all alarm log entries;
2) Toggle period selection – opens period selection controls;
3) Load the latest data – refreshes alarm log and shows last 20 log entries;
4) List of alarm log entries – entry number, date and time, source node, status and
event name;
5) Navigation controls. “<<” navigates to start of alarm log, while “>>” – to the end;
“Previous 20” navigates to previous alarm log page showing 20 previous alarm log
entries, while “Next 20” – to next alarm log page showing 20 next alarm log entries
(if available).
6) Shows number of currently viewed alarm log page. In Web GUI only last 20 pages
(400 entries) are shown. Download alarm log to view full list;
7) Filter – press to filter alarms from certain source node (e.g. Radio);
8) Alarm event log file – press on the link to download full alarm log text file.
SAF Tehnika JSC