User's Manual
Table Of Contents
- Chapter 1: OVERVIEW
- Chapter 2: INSTALLATION
- Chapter 3: WEB GUI
- Initial configuration
- Over The Air
- Networking
- Performance
- System
- FW ( Firmware upgrade
- Configuration ( IP configuration
- Configuration ( SNMP configuration
- Configuration ( Configuration file
- Configuration ( System configuration
- Diagnostic ( Loopback configuration
- Diagnostic ( Download troubleshooting file
- Tools ( License management
- Tools ( Console
- About ( About System
- About ( Copyright
- Chapter 4: INTERFACES
- CONTACTS
INTEGRA User Manual WEB GUI
39
22) IfOutOctets – The total number of octets transmitted out of the interface, including
framing characters;
23) Dot1dTpPortInFrames – The number of frames that have been received by this port
from its segment. Note that a frame received on the interface corresponding to this
port is only counted by this object if and only if it is for a protocol being processed
by the local bridging function, including bridge management frames;
24) Dot1dTpPortOutFrames – The number of frames that have been transmitted by this
port to its segment. Note that a frame transmitted on the interface corresponding to
this port is only counted by this object if and only if it is for a protocol being
processed by the local bridging function, including bridge management frames.;
25) ReceivedPkts64Octets – The total number of packets (including bad packets)
received that were 64 octets in length (excluding framing bits but including FCS
octets);
26) TransmittedPkts64Octets – The total number of packets (including bad packets)
transmitted that were 64 octets in length (excluding framing bits but including FCS
octets);
27) ReceivedPkts65to127Octets – The total number of packets (including bad packets)
received that were between 65 and 127 octets in length inclusive (excluding framing
bits but including FCS octets);
28) TransmittedPkts65to127Octets – The total number of packets (including bad
packets) transmitted that were between 65 and 127 octets in length inclusive
(excluding framing bits but including FCS octets);
29) ReceivedPkts128to255Octets – The total number of packets (including bad
packets) received that were between 128 and 255 octets in length inclusive
(excluding framing bits but including FCS octets);
30) TransmittedPkts128to255Octets – The total number of packets (including bad
packets) transmitted that were between 128 and 255 octets in length inclusive
(excluding framing bits but including FCS octets);
31) ReceivedPkts256to511Octets – The total number of packets (including bad
packets) received that were between 256 and 511 octets in length inclusive
(excluding framing bits but including FCS octets);
32) TransmittedPkts256to511Octets – The total number of packets (including bad
packets) transmitted that were between 256 and 511 octets in length inclusive
(excluding framing bits but including FCS octets);
33) ReceivedPkts512to1023Octets – The total number of packets (including bad
packets) received that were between 512 and 1023 octets in length inclusive
(excluding framing bits but including FCS octets);
34) TransmittedPkts512to1023Octets – The total number of packets (including bad
packets) transmitted that were between 512 and 1023 octets in length inclusive
(excluding framing bits but including FCS octets);
35) ReceivedPkts1024to1518Octets – The total number of packets (including bad
packets) received that were between 1024 and 1518 octets in length inclusive
(excluding framing bits but including FCS octets);
36) TransmittedPkts1024to1518Octets – The total number of packets (including bad
packets) transmitted that were between 1024 and 1518 octets in length inclusive
(excluding framing bits but including FCS octets);
37) IfInBroadcastPkts – The number of packets, delivered by this sub-layer to a higher
(sub-)layer, which were addressed to a broadcast address at this sub-layer;
SAF Tehnika JSC