User's Manual
Table Of Contents
- Chapter 1: OVERVIEW
- Chapter 2: INSTALLATION
- Chapter 3: WEB GUI
- Initial configuration
- Over The Air
- Networking
- Performance
- System
- FW ( Firmware upgrade
- Configuration ( IP configuration
- Configuration ( SNMP configuration
- Configuration ( Configuration file
- Configuration ( System configuration
- Diagnostic ( Loopback configuration
- Diagnostic ( Download troubleshooting file
- Tools ( License management
- Tools ( Console
- About ( About System
- About ( Copyright
- Chapter 4: INTERFACES
- CONTACTS
INTEGRA User Manual WEB GUI
50
7) By pressing „Execute configuration” changes made to the corresponding section
apply only for the local side Integra. If „Rollback on” is selected, configuration will be
reverted in case erroneous configuration changes are applied.
Configuration à Configuration file
1) Download configuration file – allows downloading system configuration file and
saving it on your hard drive;
2) Upload configuration file – allows uploading system configuration file from your
hard disk drive to Integra;
3) Restore uploaded configuration file – restores uploaded system configuration;
4) Load factory configuration file – resets system configuration to factory defaults.
configuration factory
Use to reset system configuration to factory defaults.
configuration load
Use to load uploaded system configuration.
configuration status
Use to check whether running configuration is saved.
configuration store
Use to save running configuration.
SAF Tehnika JSC