User's Manual
Table Of Contents
- Chapter 1: OVERVIEW
- Chapter 2: INSTALLATION
- Chapter 3: WEB GUI
- Initial configuration
- Over The Air
- Networking
- Performance
- System
- FW ( Firmware upgrade
- Configuration ( IP configuration
- Configuration ( SNMP configuration
- Configuration ( Configuration file
- Configuration ( System configuration
- Diagnostic ( Loopback configuration
- Diagnostic ( Download troubleshooting file
- Tools ( License management
- Tools ( Console
- About ( About System
- About ( Copyright
- Chapter 4: INTERFACES
- CONTACTS
INTEGRA User Manual WEB GUI
51
Configuration à System configuration
1) Enter new password (4..30 characters) – Allows defining preferable password for
‘admin’ account. Maximal length of the password name cannot exceed 30 symbols.
By default password for ‘admin’ account is ‘changeme’. Admin account has full
control of the configuration process.
2) Hide password – Hides typed in password. This option unchecked will display typed
in password in plaintext;
3) System name (<=16 characters) – allows entering preferable system name.
Maximum length of the system name cannot exceed 16 symbols. Default name is
‘SAF’;
4) Time (YY-MM-DD hh:mm:ss) – allows changing system date and time manually by
entering date and time in specific syntax;
5) Set local machine time – forces system to use the time set on your PC or laptop,
from which you are connected to the Web GUI;
6) Location – allows entering preferable system location name. Maximum length of the
location name cannot exceed 16 symbols. By default system location is not
specified;
7) By pressing „Execute configuration” changes made to the corresponding section
apply only for the local side Integra. If „Rollback on” is selected, configuration will be
reverted in case erroneous configuration changes are applied.
SAF Tehnika JSC