User's Manual

The CFIP Series Full Outdoor Unit Installation Manual • Rev. 1.3 • Software version 1.42b

STEP 4

• Enter preferable Tx power and Tx frequency;

• Press ‘Next step >>’.

STEP 5

• Check the settings;

• Press ‘Execute configuration’ to confirm your choice.

STEP 6

• Repeat STEP 1-5 for the second CFIP Lumina;

• Go to ‘Status’ screen to check link operation.

4.3 Initial configuration with command prompt

Command prompt is available using serial connection (Twin BNC) or Ethernet management port –

using Telnet or command prompt in Web interface – for further details see the “

CFIP Series Full Outdoor

Unit Technical Description and Configuration Guide

”.

Default user name for Web and Telnet access is

admin

and password is

changeme

Configuration steps using command prompt are the following:

• Check the system settings with command ‘status’

• Configuration required parameters:

– Tx power with the command ‘radio txpower [<power dBm>]’;

– Tx frequency with the command ‘radio freq [<freq KHz>]’;

– Channel bandwidth and modulation type with the command ‘modem set <bandwidth>

<modulation min> <modulation max> {StrongFEC|WeakFEC}’;

– Name of the CFIP Lumina with the command ‘system name <name>’. Default name is

‘SAF’;

– IP address with the command ‘net ip addr <addr>’, if it is necessary;

– IP mask with the command ‘net ip mask <mask>’, if it is necessary;

– IP default gateway with the command ‘net ip gw <gw>’, if it is necessary.

• Save settings with the command ‘cfg write’; restarting with the command ‘system reset’;

• Check the settings made, modem and radio status with the commands ‘status’, ‘modem status’

and ‘radio status’ respectively.

5 CFIP Lumina Full Outdoor Unit and Antenna Installation

5.1 Polarization Considerations

The position of the CFIP Lumina determines the polarization of the radio signal. The

waveguide flange can be used as the indicator, see picture in the next chapter.

When attaching CFIP Lumina to the antenna, the antenna waveguide transition

polarization must match with the CFIP Lumina polarization.

(!) Polarizations must meet as perfect as possible at both ends of the link, otherwise you will be

experiencing low RSL value.

(!) Before you set above mentioned parameters, you must know what frequency and bandwidth you may

use and at what power you may transmit.