User's Manual

The CFIP Series Full Outdoor Unit Installation Manual • Rev. 1.3 • Software version 1.42b
© SAF Tehnika JSC 2010
9
– Safari v. 3.0
– Opera v. 9.50
If everything was connected correctly, you will see a screen similar to this (with no alarm
indications):
Figure 4. Web Interface - main window
Otherwise please refer to
“The CFIP Series Full Outdoor Unit Technical Description and
Configuration Guide”
or contact SAF Tehnika JSC support team [e-mail]
STEP 1
To start basic configuration process, you must proceed with the configuration wizard.
• Go to ‘
Configuration Æ Configuration wizard ’;
• Enter system name (CFIP Lumina identification name), change password for ‘admin’ account and
specify password for ‘guest’ account. By default, the password for ‘admin’ account is ‘changeme’
and there is no password specified for ‘guest’ account;
• Press ‘Next step >>’.
STEP 2
• Enter IP address, IP mask, default gateway and remote link side IP address, if necessary; if
192.168.205.* subnet is not reserved for other purposes, it is recommended that CFIP devices
stay in the same subnet to avoid confusions regarding IP addressing;
• Press ‘Next step >>’.
STEP 3
• Enter preferable bandwidth, modulation type;
• Press ‘Next step >>’.