Manualshelf

Users Manual Part 1

ManualsBrandsSAF Tehnika ManualsElectronicsLicensed Wireless Communications Services (WCS) (2305-2320 MHz, 2345-2360 MHz)
21222324252627282930
Phoenix G2 IDU User Manual OVERVIEW
SAF Tehnika JSC
29
N-type connector
N-type Female connector for ODU interconnection to IDU with coaxial cable
Grounding screw
Grounding screws should be interconnected with grounding cable and connected to ground
circuit
SP/HP ODU with SAF2 adaptation interface
Phoenix G2 Standard Power (SP)/High Power (HP) ODU with SAF2 adaptation has
following interfaces:
Figure 1.34 SP/HP ODU with SAF2 interfaces
SAF2 adapter with UBR flange
Standard UBR flange for ODU interconnection with antenna equipped with SAF2 interface.
Flange size depends on the frequency used.
RSSI port
RSSI (Received Signal Strength Indicator) port is used to adjust the alignment of antenna for
best performance (for both rough and fine adjustment); this can be done using digital
multimeter which is connected to the RSSI port. The output of the RSSI port is DC voltage and
varies depending on received signal level.
The following chart and table shows typical relationship of the received signal level (Rx level)
displayed by Phoenix G2 vs. RSSI port output voltage. The evaluated Rx level has the error +/-2
dB.