Users Manual Part 1

Phoenix G2 IDU User Manual WEB GUI
SAF Tehnika JSC
71
Figure 3.23b “Status  Inventory” page
Config
Config  System  Mode
In this section the user can select specific Design Type which specifies the main function of
the system/link.
Figure 3.24 “Config  System  Mode” page, Design 505 configuration
1) Design Type – following two design types are supported (depending on the license):
a) Design 505 – a single IDU on each side of the link. Available modes are 1+0 (ch1,
ch2, dual FD and dual XPIC), 1+1 (FD, HSB, SD, XPIC) and 2+0 (FD, XPIC). This
design supports AES encryption if licensed.
b) Design 511 – two or more IDUs on each side of the link. This design type should be
selected for application where full protection is required. Two or more
interconnected IDUs are used on each side of a link in this configuration. At the
moment there is only Split 1+1 (FD, HSB, SD) mode available. Note that the AES
encryption is not available in this design.