Installation Manual

ManualsBrandsSafari ManualsNew Products!V-Spec Snorkel to suit Toyota Prado 90 Series 12/1997-12/2003 3.4L Petrol 5VZ-FE

Page 1 of 5

SS185HF 01/04/15

ITEM

DESCRIPTION

QTY

PART NO.

BODY - SNORKEL

395-133-000

3" AIR RAM ASSEMBLY

000-135-400

DUCT – CONNECTING

395-123-000

BRACKET – UPPER MOUNTING

390-032-000

BOLT – HEX 6mm x 1.0mm x 14mm

000-002-100

SCREW – S/T 4.2mm x 13mm

000-951

INSERT - PLASTIC

000-960

STUD – S/S 8mm x 1.25mm x 25mm O/L

000-110

WASHER – BODY 8mm x 30mm

000-311-300

NUT – NYLOC 8mm x 1.25mm

000-205-300

HOSE – RUBBER 75mm ID x 57mm

000-805-225E

CLAMP – HOSE 70/90mm

000-908

TEMPLATE

HOSE CLAMP - SIZE 48 (BLACK)

395-017-000

000-918/B

Summary of content (5 pages)

PAGE 1
SS185HF ITEM DESCRIPTION 01/04/15 QTY PART NO. 1 BODY - SNORKEL 1 395-133-000 2 3" AIR RAM ASSEMBLY 1 000-135-400 3 DUCT – CONNECTING 1 395-123-000 4 BRACKET – UPPER MOUNTING 1 390-032-000 5 BOLT – HEX 6mm x 1.0mm x 14mm 3 000-002-100 8 SCREW – S/T 4.2mm x 13mm 5 000-951 9 INSERT - PLASTIC 4 000-960 10 STUD – S/S 8mm x 1.25mm x 25mm O/L 5 000-110 11 WASHER – BODY 8mm x 30mm 5 000-311-300 12 NUT – NYLOC 8mm x 1.
PAGE 2
WARNING!! IT IS AN INSTALLER RESPONSIBILITY TO VERIFY ALL COMPONENTS, AND PARTICULARLY THE TEMPLATE ARE CORRECT, BEFORE STARTING ANY PART OF THE SNORKEL INSTALLATION. (CHECK TEMPLATE AGAINST SNORKEL BODY) Copyright Safari 4x4 Engineering Pty Ltd Melbourne Victoria Australia – www.safrai4x4.com.
PAGE 3
SS185HF To Suit: TOYOTA LANDCRUISER PRADO Fitment to: Right hand side Fitting time: Approximately 120 minutes Special Tools: 83mm hole saw Step drill Air hacksaw 3.4L V6 PETROL (5VZ-FE ENGINE) Instructions: 1. Remove the RHS front wheel arch liner and air inlet ducting. 2. Remove air cleaner assembly from vehicle and remove air cleaner entry duct by drilling out rivets. 3. Tape the template to the upper rear corner of the right hand guard. With a felt tip pen, mark out all holes.
PAGE 4
NEW ZEALAND INSTALLATIONS ONLY : Safari have developed 2 methods of Snorkel A pillar attachment, for the conventional method please proceed with the current document alternatively please see the link below for further instructions. www.safari4x4.co.nz/apillarmounting 5. Install mounting studs and upper mounting bracket to the Snorkel body. Position Snorkel on guard and mark out around the outside edge of the upper mounting bracket. 6. Remove Snorkel body from vehicle and remove upper mounting bracket.
PAGE 5
Copyright Safari 4x4 Engineering Pty Ltd Melbourne Victoria Australia – www.safrai4x4.com.