Instructions / Assembly

Find the center of the top and bottom lines and draw a vertical line connecting these two points.
Now find the midpoint between the center line and the right side of the mirror, and the center line and the left side of your mirror. Draw two more vertical lines connecting the
top and bottom outline of your mirror to these points.
Now, measure approximately one third down from the top of the mirror and make a mark on these lines. These will be the anchor points to use to hang your mirror.
INSTALLING WALL ANCHORS & MOUNTING HOOKS.
Determine if there are wooden wall studs directly behind the anchor mounting marks. You can do this with a stud finder purchased from a hardware store, or by drilling a small
pilot hole. If the drill bit hits wood, you’ve found a wall stud. If it hits nothing and goes straight through, there is no stud and you’ll need to use a wall anchor/shield.
For walls with wooden studs directly behind the anchor points, simply drill two small pilot holes into the wall at the anchor points and use the screws provided to hang your
mirror.
For mounting areas without wood studs directly behind the anchor marks, you’ll need to use wall anchors/shields to secure the screws to the wall. Drill a hole in the wall at each
anchor mark and then push the wall anchor/shield into this hole. Now simply screw the mounting screws into the wall.
After installing your screws, place the wire on the back of the mirror frame onto your screws (leave screws extended approx. 1/8 inch from the wall) and step back to visually
inspect the placement of your mirror.