Installation Guide

Find the center of the top and bottom lines and draw a vertical line connecting these two points.
Now find the midpoint between the center line and the right side of the mirror, and the center line and the left side of your mirror. Draw two more
vertical lines connecting the top and bottom outline of your mirror to these points.
Now, measure approximately one third down from the top of the mirror and make a mark on these lines. These will be the anchor points to use to
hang your mirror.
HOW TO HANG A MIRROR OVER FURNITURE OR FIREPLACE MANTEL
When hanging a mirror over a sofa or furniture that is less than 30” tall, follow the instructions for placing the mirror at eye level (approx. 60”– 65”
from the floor).
Mirrors placed above a dining room sideboard, server or buffet console can be hung lower on a wall to account for the change in eye level when
people are seated at a dining room table.
For taller pieces of furniture (cabinets, bookcases etc.) the space between the bottom of the mirror and the top of your furniture should be approx-
imately 4” – 8”. For taller furniture leave a smaller gap in order to keep the mirror as close to eye level as possible.
When hanging a mirror above a fireplace mantel, leave a 4”- 6” gap between the bottom of the mirror and the top of the mantel, depending on the
size of the frame and the shape of the mirror. When in doubt, always err on the side of hanging the mirror slightly lower on the wall.
INSTALLING WALL ANCHORS & MOUNTING HOOKS.
Determine if there are wooden wall studs directly behind the anchor mounting marks. You can do this with a stud finder purchased from a hard-
ware store, or by drilling a small pilot hole. If the drill bit hits wood, you’ve found a wall stud. If it hits nothing and goes straight through, there is no
stud and you’ll need to use a wall anchor/shield.
For walls with wooden studs directly behind the anchor points, simply drill two small pilot holes into the wall at the anchor points and use the
screws provided to hang your mirror.
For mounting areas without wood studs directly behind the anchor marks, you’ll need to use wall anchors/shields to secure the screws to the wall.
Drill a hole in the wall at each anchor mark and then push the wall anchor/shield into this hole. Now simply screw the mounting screws into the wall.
After installing your screws, place the wire on the back of the mirror frame onto your screws (leave screws extended approx. 1/8 inch from the wall)
and step back to visually inspect the placement of your mirror.