Instructions / Assembly

Assembly Instruction

CAUTION: Read instruction carefully and turn electricity off at main circuit breaker panel

before beginning installation.

ITEM#: PLT4002A

Care and Cleaning

To clean the outside of the fixture, use a dry or slightly dampened clean cloth(use clean

water, never a solvent) to wipe the surface of the fixture.

To clear the inside of the fixture, first disconnect power to the fixture by turning off the

circuit breaker or by removing the fuse at the fuse box. Next, use a dry or slightly

dampened clean cloth(use clean water, never a solvent) to wipe the interior surface of the

fixture

Do not use any cleaners with chemical, solvents or harsh abrasives. Use Only a dry soft

cloth to dust or wipe carefully.

Estimated Assembly Time:20 minutes

Part List and Hardware List

PIECE

DESCRIPTION

PICTURE QUANTITY PIECE DESCRIPTION PICTURE QUANTITY

mounting

bracket

1X F wire connector 3X

machine

screw

2X G

mounting

screw

C backplate 1X H ground screw 1X

D washer 4X J Frame 1X

E Cap Nut 2X k Studs 2X

PAGE 1
Assembly Instruction CAUTION: Read instruction carefully and turn electricity off at main circuit breaker panel before beginning installation. ITEM#: PLT4002A Care and Cleaning To clean the outside of the fixture, use a dry or slightly dampened clean cloth(use clean water, never a solvent) to wipe the surface of the fixture. To clear the inside of the fixture, first disconnect power to the fixture by turning off the circuit breaker or by removing the fuse at the fuse box.
PAGE 2
Installation Step 1 Loose the Screws(K) to remove the polyfoam from the Frame(J) Step 2 Install the mounting bracket(A) to the junction box with machine screw (B) Step 3 Wire connection Make wire connections, with wire connectors(F), following the reference chart listed below.