Installation Guide

INSTALLING WALL ANCHORS &
MOUNTING HOOKS FOR WALL DECOR
Determine if there are wooden wall studs directly behind the
anchor mounting marks. You can do this with a stud finder
purchased from a hardware store, or by drilling a small pilot hole.
If the drill bit hits wood, you’ve found a wall stud. If it hits
nothing and goes straight through, there is no stud and you’ll
need to use a wall anchor/shield.
For walls with wooden studs directly behind the anchor points,
simply drill two small pilot holes into the wall at the anchor
points and use the screws provided to hang your mirror.
For mounting areas without wood studs directly behind the
anchor marks, you’ll need to use wall anchors/shields to secure
the screws to the wall. Drill a hole in the wall at each anchor
mark and then push the wall anchor/shield into this hole. Now
simply screw the mounting screws into the wall.
After installing your screws, place the wire on the back of the
mirror frame onto your screws (leave screws extended approx.
1/8 inch from the wall) and step back to visually inspect the
placement of your mirror.