Installation Guide

2. Camera & Phone Pairing
1. Plug USB power cable to the back of the camera.
After pressing the power button on the back of the
camera, wait for 25 seconds for the camera to activate,
the indicator will flash green. When connected to the
internet, the flashing green stops and becomes constant.
2. Wifi Setup : With An Ethernet Cable or Smart Pairing
4a. Wifi setup with Ethernet Cable :
A - Connect Ethernet cable to the Ethernet port
on the back of the Camera.
B - Go to Wireless Settings within the Safe Grow
App and connect to the local Wifi.
C - When Wifi is successfully setup, disconnect
the Ethernet cable.
4b. Wifi setup with Smart Pairing :
A - Place smart phone within 3 inches of Camera.
B - An audible sound will begin to play from the
smart phone, make sure to hold the smart
phone within close proximity to the camera.
C - Press Go icon to pair.
3. Press
+ Add Camera to add camera.
4. Scan QR code or key in with Manual input,
( QR code and default password located on
the back of camera ).