Service manual

12 SiteStand Mobile Docking Station Service Manual
3.3.4 Repairing or Replacing the Front Panel Connectors
and the Power Supply
1. To access the connectors and the power supply use a #1 philips screwdriver to
remove the six connector cover philips screws. Pull the connector cover off and
set it aside.
2. Extend the gas spring to its maximum height by pressing the foot pedal.
3. Remove the blade cap by gently prying it up from the sides with a flat blade
prying tool. There are no screws holding it in place. The blade cap can also be
removed by removing the SiteStand station base assembly and using a long
blunt tool pushing up from the bottom of the blade assembly. This method will
prevent possible damage caused by prying the blade cap off.
4. Lift the blade cap to the top of the shaft and secure it in place out of the way.
5. Remove the two flat head 1/8 allen screws from the subplate at the end of the
blade assembly nearest the connector panel. Remove the two 5/32 allen screws
located closest to the sides of the blade assembly at the end of the blade
assembly with the shaft.
6. Gently lift the subplate up and rotate it on the shaft to gain access to the
connector panel.
7. Gently pull the connector assembly out the top of the blade assembly. Note the
attaching tabs at the top and bottom. This is important for successful reassembly.
8. Any of the connectors and/or the power supply can now be repaired or replaced.
9. To reassemble the SiteStand station perform the preceding steps 1 through 8 in
reverse order.