User`s guide

AIRSHIP © 2009
Page 80
Move To Preset: If checked, the PTZ camera on this channel will go to a pre-defined
Preset. See the PTZ Preset section for details.
Notify Client: Sends a message to any Clients currently connected to this Camera.
Record: If checked, the Alarm condition will result in recordings captured for the
channels specified on the Record tab under Alarms. The default is the same Camera
number for which we are currently configuring Alarms.
Output to Relay: If checked, the Alarm condition will cause the output relays
configured on the Alarm Relays tab to be triggered.
Send Email: Sends an Email alert as defined in the Network configuration.
For Motion Detection there are two settings for Email Alerts:
For a Motion Detection alarm, the Server can send an email with a number of
automatically created snapshot images from the camera. Check your Email settings if
you have not done so already.
Snapshots to Email: How many Snapshots to send.
Snapshot Delay: Time to wait between Snapshots.
For Video Source Tampering there are two special settings:
Duration to Trigger: This setting indicates how long the Camera scene appears to be
tampered with before the Alarm is triggered. For example, a hand briefly covering
the scene may not be enough to trigger the Alarm, but paint sprayed over the lens
would trigger after a few seconds. NOTE: The Pre-Record setting should be set to a
higher value than the Duration To Trigger so there is a better chance of recording
what occurred before the tampering.
Threshold: This setting governs how much of the scene must be covered or
'tampered' with for the alarm to trigger. The default, 5, indicates about half the
screen.