Safeline Corp.
U.S. Patents #5.104.134 and 4.620.771 lntcrnafional Patents Listed Inside SAFELINE gCORPORATION” 1-800-829-I 625 1777 South Bellaire Street, Suite 330 + Denver, Colorado 80222 Phone: (303) 757-2400 + Fax: (303) 757-1988 E-mail: service@safelinecorp.com + Website: www.safelinecorp.com Safellne Corporation TM SIP ‘n’ StrollTM 5.
Thank you for purchasing the Sit’n’Stroll5-in- 1 Combination Car Seat/StrollerTM. The Sit’n’StrolP is the most advanced car seat/stroller available, and we believe the simplest, safest and most convenient way to travel with an infant. The most important benefit the Sit’n’StrollTM can provide is increased protection for your child. Studies have shown the use of a child restraint system reduces the likelihood of death and injury caused by the tremendous forces involved in an automobile accident.
Limited Six Month Warranty All Safeline products purchased from an authorized Safeline dealer are warranted against defective materials and workmanship for six months from the original date of purchase. This warranty does not include any problems associated with normal wear, abuse, misuse or negligence by the purchaser. This warranty also does not apply to any Safeline product purchased secondhand.
Table of Contents Warranty Get to KnowYour Sit’n’StrollTM Safety Guidelines Securing Your Child in the Sit’n’StrolP Installing the Sit’n’StrollTM in Your Vehicle: Choosing an Appropriate Determining the Correct Rear-Facing Position Forward-Facing Position Vehicle Seating 6 7 8 9 11 11 13 14 15 16 17 18 21 Seat Position Installing the Sit’n’StrollTM on an Aircraft Converting the Sit’n’Stroll TMfrom Car Seat to Stroller Operating the Sit’n’Stroll Brakes Converting the Sit’n’StrollTM from Stroller to Car S
A# AY WARNING FAILURE TO FOLLOW EACH OF THE INSTRUCTIONS CAN RESULT IN YOUR CHILD STRIKING THE VEHICLE’S INTERIOR DURING A SUDDEN STOP OR CRASH. Get to Know Your Sit’n’StrollTM Stitch Line, Telescoping Handle / . Primary Forward-Facing Harness Position (For children who weigh 28 pounds and over) Secondary ForwardFacing Harness Position (For children who weigh less than 28 Adjustment Buckle /I I I Harness I / !I Crotch ,.
Safety Guidelines Always use good common sense! If you have questions about your Safeline product, please call us at 800-829-l 625 or 303-757-2400. Do not place this rear-facing car seat in a vehicle seat with a passenger side air bag. In the event of a collision or sudden stop, the force of an inflating air bag can cause serious injury or death. Not following this warning places your child at serious risk.
Securing your Child in the Sit’n’StrollTM On hot or sunny days, always check the fabric and metal buckles before placing your child in the restraint to avoid burns or discomfort. 1. To unlock the restraint harness, press the red buckle release button and pull the two metal Lclips out of the buckle. 2. Place your child in the Sit’n’StrollTM. Ensure the harness passes snugly over your child’s shoulders and each leg, and then snaps into the crotch buckle.
infants and other small children may require additional head and posture support when using the Sit’n’StrolP to avoid injury or suffocation. Bolsters may assist in supporting the neck and head of a small child. Retailers of children’s products generally carry bolsters in their accessory aisles. If you have questions regarding bolsters, please contact Safeline or the American Academy of Pediatrics.
Do not place this rear-facing car seat in a vehicle seat with a passenger side air bag. In the event of a sudden stop or collision, the force of an inflating air bag can cause serious injury or death to a child. Not following this warning places your child at serious risk. Owners of vehicles with passenger side air bags should refer to their owner’s manual for child restraint installation instructions.
Placing your child in the or she is over one year old your child at serious risk. Before placing your child in the forward-facing position, consider both the weight and age guidelines for the forward-facing postion. Consult with your physician to determine the individual needs of your child. lnsfalling the Sit’n’SfrollrM in the Rear-Facing Position 1. Thread the vehicle seat belt under the rearfacing tabs on the armrests of the Sit’n’StrollTM.
If the vehicle seat belt loosens, twist the adjustment buck/e and the end of the be/t twice before buckling it. This should prevent the adjustment system from inadvertently loosening. If the lap belt you are using will not hold the unit firmly in place or will not reach around the car seat, use another seating position in the vehicle. If no other position exists with a lap belt that will remain tight, contact your auto dealer to have one installed.
Shoulder Belt Primary Forward/ Facing 1. Pull the vehicle seat belt around the front of the Sit’n’Stroll and position it tightly between the primary forward-facing tabs. Secure the vehicle seat belt on the other side of the Sit’n’StrollTM in the vehicle seat buckle. Rock the Sit’n’StrollTM from side to side to ensure the vehicle seat belt holds the unit firmly in place. Primary Forward-Facing Seat Belt Position 2.
Installing the Sit’n’StrollTM on an Aircraft Contact the airline prior to taking the child restraint on board the aircraft. Install the Sit’n’StrollTM in the airline seat the same way you would when using it in a car. You may need to raise the armrests in the aircraft to allow room for the Sit’n’StrollTM. After the Sit’n’StrollTM is in place, you can usually lower the armrest back into place.
The Sit’n’StroP is designed to be converted from car seat to stroller and back again while holding the child, still secured in the Sif’n’Stro//~“, OFF THE GROUVD. If the Sif’n’StroP is converted on the ground, the mechanism may jam. The Sit’n’StrolF is to be used only by one child at a time. Never p/ace more than one child in the seat. Until you are well practiced in following these instructions, do not attempt to convert from car seat to stroller or vice/versa with your child in the seat.
3. Release Tabs I With one hand, compress the red handle release tabs located under the stroller handle, and with the other hand, pull up on the stroller handle. Select one of the four (4) handle height positions and release the red handle release tabs to lock the stroller handle into place. Never use the stroller when 4 holes are showing on the handle tube. Always ensure the red handle release tabs are engaged with one of the four sets of holes in the handle tubes.
Converting the Sit’n’StroP 1. 2. 3. from Stroller to Car Seat Compress the red handle release tabs and push the stroller handle down until it locks in its lowest position. Align the front wheels by rolling the stroller back 6 to 12 inches. Place one hand in the slot handle located between your infant’s feet. With your other hand, grasp the slider grip located on the back of the seat. Lift the seat off the ground.
The Sit’n’StrolP Sunshade Head Hole #2 Hole #3 -3 Tension Cord Attaching the Sunshade 1. Attach the head rest clips to the top of edge of the seat back, on either side of the handle tubes. 2. Push the edge of the seat cover forward exposing the plastic shell. Locate the third hole down from the top. 3. Keep the seat cover fabric pushed forward and press the push pin (sewn into the bottom portion of the sunshade) into the third hole until it clicks into place.
Adjusting the Harness For your child’s safety, the Sit’n’StrollJM utilizes a continuous-loop 5point harness system-the kind most recommended by safety experts. Never use the Sit’n’StrollJM without securely buckled. the harness Metal Slide (Back of Shell) Chest Clip Adjustment Slide Crotch Buckle with Left and Right Clips Generally speaking, the tighter the harness, the more effective it will be in protecting your child in the event of a sudden stop or collision.
I’ ...‘..“.’ Chest Clip Adjustment Slide The harness must a/ways be routed through (i.e. behind and under) the plastic shell. Never route the harness through the fabric cover only. After making harness adjustments, ensure the harness is threaded through the adjustment buckle properly. (See adjustment slide detail above). Removing ’ Adjustment Buckle ’ Chest Clip the Harness 1. The excess harness is stored under the fabric seat cover on your child’s left side.
3. Unthread the harness from the black chest clip on the child’s right side. 4. Turn the Sit’n’StrollTM around and face the back of the car seat. Pull the harness through the back of the seat, and out of the metal slide (on the back of the seat). 5. Face the front of the stroller and pull the harness out of the slot on the left side of the seat where your child’s back rests. 6. The harness should now be completely clear of the stroller. If you plan to wash the harness, remove the black chest clip.
Metal Slide 3. Locate the three levels of slots on the body of the seat (where your child’s back will rest). Select the level that fits your child and thread the open end of the harness through the slot on the right (from front to back) through the car seat. Pull the harness through until the silver buckle is about two to three inches above the bottom of the seat. 4. Turn the unit around so you are facing the back side of the car seat.
Make Loop Large Enough Your Child’s Leg to Fit 8. Locate the slot in the fabric cover and seat shell located near your child’s right hip. Push the harness through this hole, reach under the stroller and pull the harness through. Leave a loop of harness large enough for your child’s leg between the silver L-clip and the slot on the bottom of the seat. Also ensure you leave enough room for your child’s shoulders in the shoulder belt area. 9.
Maintenance Washing and Care the Cover 1. 2. 3. and Harness Remove the harness from the Sit’n’StrollTM and detach all buckles. Release the clips securing the fabric cover to the car seat and remove the cover from the plastic shell. Wash the cover and harness in cold water on gentle cycle with a mild detergent. Do not use bleach. Hang the fabric cover to dry or tumble dry without heat. Do not dry in a heated dryer.
800-829-I 625 Made in Taiwan, R.O.C.
CORPORATION’” SAFELINE Booster Seat Patents Pending l-800-829-1625 Safeline Corporation TM Booster Seat page 1 of 7
Limited Six-Month Warranty All Safeline products purchased from an authorized Safeline dealer are warranted against defective materials and workmanship for six months from the original date of purchase. This warranty does not include any problems associated with normal wear, abuse, misuse or negligence by the purchaser. This warranty also does not apply to any Safeline product purchased secondhand.
Table of Contents Warranty Quick Reference Chart General Safety Using the Proper Vehicle Safety Belt System Using an Appropriate Vehicle Seat Installing the Safeline Booster Seat (Models #4000 and #4500) Correct Shoulder Belt Position Installing the Safeline Booster Base (Model #4800) Attaching the Safeline Booster Seat Accessories Caring for Your Safeline Booster Seat The Safeline Booster Seat 1 3 3 4 4 5 6 627 83 9 Quick Reference Shoulder Belt Positioner , , iF Padded Lumbar and Torso supports Remov
Installation WARNING! USE ONLY THE VEHICLE’S LAP AND SHOULDER BELT SYSTEM WHEN RESTRAINING THE CHILD IN THIS BOOSTER SEAT. USE OF OTHER TYPES OF VEHICLE SEAT BELT RESTRAINTS MAY NOT PROPERLY SECURE YOUR CHILD WHEN USED WITH THE SAFELINE BOOSTER SEAT, AND MAY CAUSE SERIOUS INJURYTOYOUR CHILD IN THE EVENT OF A SUDDEN STOP OR COLLISION. Using the Proper Safety Belt System The Safeline booster seat should not be used in boats or on motorcycles.
Correct Shoulder Installing Belt Position If you have chosen the correct slot in the belt-positioner, the picture on the far left. the Safeline Booster Base (continued) Model #4800 the belt should look like Determine the safest position in the vehicle to install the Safeline booster base. The back seat is the safest place for children 12 years and younger. Place the Safeline booster base on the vehicle’s seat, making sure it is firmly pressed against the vehicle’s seat back.
Installing Always Use Good Common Never let children objects while traveling Attaching the Booster Installing Drop me SiOf The cup holder be nstailed the Cup Holder on e!ther the nghf or left s/de will lead to years of enjoyment while not a restraint device and is meant for the following installation instructions to a sudden stop or collision. the Accessory Installation 1 Tab Tray Cup Holder Tray Tower r“ SW#l1 .
800-829-1625 Made in Denver, Colorado Cover Sewn in Mexico Safelrne CorporahonTM Booster Seat page 7 of 7
