User's Manual

You may reset the low battery alarm for 12 hours by

pressing the OK-button.

If the batteries are not replaced, Safera Sense switches

itself off when the batteries are fully depleted. If the

system is equipped with the optional Power Control Unit

(PCU), it will also shut down the electric power to the

stove.

6.3. Battery replacement

Remove the sensor unit from the mounting bracket by

pulling it gently.

Remove the empty batteries.

Place the new AA/LR6 Alkaline batteries in the sensor unit.

Notice the correct battery orientation marking inside the

battery compartment, where the “+”-symbol marks the

positive terminal of the battery according to this picture:

Place the sensor unit back onto the mounting bracket.

7. Troubleshooting

Press the OK-button to find out the problem type. The

indicator light:

Blinks in blue

Blinks in yellow

Once: Problem with

wireless connection.

Twice: Problem with

the optional Power

Control Unit.

Three times: Power

Control Unit over-

heating.

Once: Problem with sensors

Twice: Problem with sensor

unit electronics or software

Three times: Faulty

installation position of the

sensor unit: see remedy on

the table below.