User's Manual

13
10. Conformity
Safera Oy declares that Sense is in compliance with the
following EU directives and standards. Full text of the EU
declaration of conformity is available at the following
internet address: www.safera.com/support/doc/sense
Directives: 2014/53/EU, 2015/863/EU, 2011/65/EU,
2012/19/EU
Stove guard performance, only for electric hobs, only
when used in conjunction with the optional Power Control
Unit (PCU): EN 50615:2015 (Category B)
Safety: IEC/EN 62368-1:2014 + AC:2015 +A11:2017
EMC: EN 301 489-1 V2.2.0, EN 301 489-17 V3.2.0
RF: EN 300 328 V2.1.1, EN 62311:2008
FCC ID: 2AT88-1000021194
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
This device complies with FCC RF exposure limits and has
been evaluated in compliance with mobile exposure
conditions. The antenna must be installed and operated
with minimum distance of 20 cm between the radiator
and your body.
Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
Class B device notice
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures: —Reorient or relocate the receiving antenna. —
Increase the separation between the equipment and
receiver. —Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected. —Consult the dealer or an experienced
radio/TV technician for help.
Mikko Reinikainen, CEO
Espoo Finland 19.8.2019