Instructions / Assembly

Assembly Instructions
Wire Shelves
Prop 65 Warning: This product can expose you to chemicals including lead, which is known to the State of
California to cause cancer. For more information, visit www.P65Warnings.ca.gov
Components:
Post x8
Clip Sleeves x32/40/48*
Wide Top Caps x8
(for dual/extended unit assembly)
Adjustable Feet x8
Slim Top Caps x4
(for single unit assembly)
Threaded Inserts x4
(for single unit assembly)
Wire Shelf x4/5/6*
Casters x4 *
(not included in 14x30x60)
* quantities vary by shelf size
1
Assemble adjustable feet to first set of
posts. If using casters, install them at the
end to prevent the unit from moving during
installation.
2
Install 4 clip sleeve pairs at desired shelf
height (bring clips together above desired
groove and lower until a “click” is heard).
Always follow directional arrows.
3
Assemble top posts using the threaded
inserts and install slim top caps. Repeat
step 2 until fully assembled.
Lower
shelf
Single Unit Assembly Guide
If you wish to install your wire shelf as a single unit, follow the instructions below.
NOTE: Circular, plastic tops between
shelves are used for packaging ONLY.
Contact our customer
support team:
PHONE:
[phone]
EMAIL:
[e-mail]
WEB:
www.saferacks.com
CUSTOMER SERVICE
NEED ASSISTANCE?
Assemble as single,
dual, or extended units
(see backside)