Instructions / Assembly

Table Of Contents

Assembly Instructions

WARNING:

This product contains chemicals such as lead, which is

known to the State of California to cause cancer and birth

defects and other reproductive harm.

For more information, go to

www.P65Warnings.ca.gov

Total Weight Capacity

500 Lbs (65 Lbs Per Hook)

(Hardware Also Included)

Required Tools:

Components:

PAGE 1
Assembly Instructions Total Weight Capacity 500 Lbs (65 Lbs Per Hook) Components: (Hardware Also Included) WARNING: This product contains chemicals such as lead, which is known to the State of California to cause cancer and birth defects and other reproductive harm. For more information, go to www.P65Warnings.ca.
PAGE 2
Wall Track Installation 1. Locate and mark studs where you want to install the rail. Maximum rail weight capacity can be achieved if 4 studs across 48” span can be located. 16” 16” 16” 2. Start by lining the first set of holes in the middle of the first stud. Ideally, the last set of holes on the rail should end in the middle of the last stud. 3. Level the rail. 24” 24” 4.
PAGE 3
Hook Installation 1. Choose your desired placement. Notch the top back end of the hook over the upper lip of the rail cover. 2. Press down on the bottom of the hook until it snaps into place. Check to ensure the hook is securely fastened to the rail. 3. Some hooks come with a locking mechanism. To install these hooks, simply repeat steps 1 and 2 while holding down the security button. Ensure the hook is fully locked onto the rail.