Instructions / Assembly

Wall Track Installation
1. Locate and mark studs where you want to install the rail. Maxi-
mum rail weight capacity can be achieved if 4 studs across 48”
span can be located.
2. Start by lining the first set of holes in the middle of the first stud.
Ideally, the last set of holes on the rail should end in the middle of
the last stud.
3. Level the rail.
4. Mark the top and bottom holes over stud with “A” to denominate
stud and mark the top holes every 8” in between studs with “B” to
denominate drywall.
5. Over the studs (mark “A”), drill 1/8” pilot holes.
On the drywall (mark “B”), drill 5/16” holes.
6. Insert drywall anchors into 5/16” holes.
7. Mount the rail onto the wall using the screws provided in the
fastener kit.
8. Slide the rail cover over the steel rail mount until the steel rail
mount is entirely covered. (Figure 1)
9. If you do not have room to slide the rail cover over the steel rail
mount, you can snap it on by lining the slot at the top of the steel
rail mount (Figure 2), then slowly push the lower edge of the rail
cover and work your way to the other side until the cover is fully
engaged with the rail mount. (Figures 3)
Figure 1
Figure 2
Figure 3
24”
24”
16”
16” 16”