User manual

13
intended for the host, and defense zones 000-007 are mixed wired/wireless defense
zones in which it is not recommended to install wireless detectors.
(I)
(I)
(I)
(I) Add/Delete
Add/Delete
Add/Delete
Add/Delete Remote
Remote
Remote
Remote Controllers
Controllers
Controllers
Controllers
The host can learn codes with 5 remote controllers, which are numbered 10 ，
11 ， 12 ， 13 ， 14 respectively.
To add/delete remote controllers, please follow the following procedures:
1.
1.
1.
1. Add
Add
Add
Add Remote
Remote
Remote
Remote Controller
Controller
Controller
Controller (Take
(Take
(Take
(Take Remote
Remote
Remote
Remote Controller
Controller
Controller
Controller 10
10
10
10 for
for
for
for example)
example)
example)
example)
Step 1: Enter “ # # # ” , and then the alarm host gives out a voice prompt that
“ Please enter a pre-set password ” .
Step 2: Enter password “ 112233 ” and “ # ” after password , and then the alarm host
gives out a voice prompt that “ The alarm host is entering into adjustment mode ”
( “ 112233 ” is a factory default password for the host and can be modified. ).
Step 3: Set the host when the “ SET ” indicator of the host lights up.
Step 4: Enter “ 12*48 ” and “ # ” after password , and then the alarm host gives out a
voice prompt “ The alarm host is entering into code learning mode ” (Note: The
host interface will display “ b ” when you enter “ * ” . ).
Step 5: Enter “ 10 ” (remote controller No.) and “ # ” after 10, and then the host gives
out a voice prompt “ Press remote controller “ ARM ” key ” .
Step 6: Press remote controller “ Full Arm ” key, and then the host gives a voice
prompt “ Ding ” , which means the host have successfully learnt code with the
remote controller.
“ Full Arm ” Key: Press “ Full Arm ” key to enter into “ Full Arm ” mode. The
function of “ Full Arm ” key is the same as that of F2 shortcut key on the keyboard