User manual

17
those of adding a detector, so please refer to the first four steps of the procedure for
adding a detector.
Step 5: Enter “ 010 ” and “ * ” , and then the host will give out a voice prompt “ Now,
the host is serving a fully armed zone. Please enter the attribute of the defense
zone ” (The attribute of all defense zones is set to “ Fully Armed Zone ” as default.
To modify the attribute of defense zone 010 from doorbell zone to fully armed
zone, enter “ 010 ” and “ * ” , and then the host will give out a voice prompt “ T he
host is serving a doorbell zone now. Please enter the attribute of the defense
zone ” . ).
Step 6: Enter “ 4 ” and “ # ” , and then the host will give out a voice prompt “ Now,
the host is serving a doorbell zone ” ( 1# fully armed zone, 2# partially armed
zone, 3# emergency zone, 4# doorbell zone, 5 # shielded zone ).
【 Note 】 a. The attributes of other defense zones shall be modified in accordance
with the same procedure.
b. To modify the attributes of defense zones continuously, enter 011* after
theattribute of the first defense zone is modified, and then the host will give out
avoice prompt “ The host is serving a fully armed zone now. Pleaseenter the attribute
of the defense zone ” ( 1# fully armed zone, 2# partially armed zone, 3# emergency
zone, 4# shielded zone, 5 # doorbell zone ).
Precautions
Precautions
Precautions
Precautions
1. Each wireless code (including remote control code and detector code) is not
learned twice by the same alarm host. For changing the first defense zone into the
second defense zone, delete the code for the first defense zone first.
2. Once the remote control or detectors transmit alarm signals, the alarm host
will give out sound prompt, which signifies code learning is successfully
completed. After code learning is successfully completed, necessary recheck shall
be performed to check if code learning is successfully completed.
3. If there is no correct operation for successive 30 minutes, the system will
automatically exit set-up mode.