User manual

19
6) Dialling Times: 5
7) Siren Duration: 30 minutes
8) Leaving Time: 5 seconds
9) Entry Time: 0 second
10) Ringing Times Set via Remote Control: 9 times
11) Defense Zone Attribute: Full Arm
3. Detailed Programming Operation of Alarm Host
All programming operations below shall be performed in set-up mode.
The Procedure for Entering into Set-up Mode:
Step 1: Enter “ # # # ” through the keyboard panel of the host
—— Users can hear a voice prompt “ Please enter the preset password ” , and the
“
SET
”
indicator lights up.
Step 2 : Enter A A A A A A # through the keyboard panel of the host
—— The format of user password is AAAAAA , and the factory default password is
“ 112233 ” . If user password is correct, users can hear a voice prompt “ The
alarm host is entering into adjustment mode ” . And then users can continue with
the next step. If user password is wrong, the system will exit set-up mode, and
at the same time, the set-up indicator goes out.
Note:
Note:
Note:
Note: As mentioned above, the following programming operations shall be
performed after the host enters into set-up mode. If any error occurs during set-up,
enter 0# (the system gives out a voice prompt “ Back ” ) to the previous step. Once
set-up is completed, enter 0 # 0 # to exit set-up mode (the system gives out voice
prompt “ Back-Exit Set-up ” ).
1) Select Alarm Mode
① Command Function: Telephone Alarm Mode
Command Grammar: 1 #
Function Description: This command enables the host to work under
telephone alarm mode and to cancel all alarm information displayed on the host.
Operating Steps: “ ### ” （ Please enter the preset password ） + “ 112233# ” （ The
host enters into adjusting mode ） + “ 1# ” （ The host is fully armed,
and telephone alarm mode is activated ） .