User manual

23
For the first two steps, please refer to the above mentioned procedure in SET mode.
Step 3: Enter 19 and # , and then the host will warn users through voice message to
delete all informed phone numbers ” .
Step 4: Press “ # ” key again, and then the host will indicate a remote controller has
has
has
has
been successfully deleted.
② Command Function: Set Ringing Times by Remote Control
Function Description: “ D D ” is ringing times (05-15) set to determine when
the alarm host will enter into long distance set-up mode. “ D D ” must be a 2-digit
number. When ringing times reaches a pre-set value, the alarm host will enter into
long-distance set-up mode. Set-up shall be done according to long distance set-up
table.
Operating Steps: “ ### ”
（
Please enter the preset password
）
+ “ 112233# ”
（
The
host enters into adjusting mode ） + “ 37# ” （ Please enter ringing times ） + “ 09# ” （ The
host gives out a voice prompt “ Ding ” to indicate ringing times has been successful
set up ） .
③ Command Function: Set Dialling Times
Function Description: “ D D ” is dialing cycle number (01-99) and must be a
2-digit number. Dialing cycle refers to a cycle during which the alarm host dials
phone numbers from first to last when an alarm occurs or the system reports the
alarm.
Operating Steps: “ ### ” （ Please enter the preset password ） + “ 112233# ” （ The
host enters into adjusting mode
）
+ “ 38# ”
（
Please enter dialling times
）
+ “ 05# ”
（
The
host gives out a voice prompt “ Ding ” to indicate ringing times has been successful
set up ） .
5. Set Alarm Sound Volume
① Command Function: Select on-site alarm volume
Command Grammar: 2 4 # , 2 5 # , 2 6 # , 2 7 #
Function Description:
Press 2 4 # to select the small on-site alarm volume;