User manual

27
⑤ Command Function: Set dialling times
Command Grammar: 3 8 # D D #
Function Description: “ D D ” refers to dialing times (01-99), namely how
many times the host dials phone numbers according to a list of preset phone
numbers. Note: This set-up does not apply when the host dials phone numbers of the
alarm receiving centre.
Operating Steps: “ ### ”
（
Please enter the preset password
）
+ “ 112233# ”
（
The
host enters into adjusting mode ） + “ 38# ” （ Please enter dialling times ） + “ 05# ” （ The
host gives out a voice prompt “ Ding ” to indicate dialling times has been successfully
set up ） .
9. Set Security ID
Command Grammar: 4 0 # D DDD #
Function Description: This alarm host will transmit alarm information to the
alarm receiving centre when an alarm is triggered under phone alarm mode. The
alarm host adopts Ademco Contact ID protocol to transmit information. XXXX is a
4-digit host ID set by users.
VIII.
VIII.
VIII.
VIII. Operating
Operating
Operating
Operating Instructions
Instructions
Instructions
Instructions
This host has two types of passwords, namely user password and set-up
password. User password is only used to arm/disarm the host, perform phone remote
control & monitoring, as well as play back siren and record. Set-up password
enables the host to enter into set-up/learning mode. Press ### + set-up password + #
to enter into set-up/learning mode.
1. Arm/Disarm
Arm/Disarm
Arm/Disarm
Arm/Disarm
1. Arm/Disarm by external keyboard of the alarm host.
Press F1 key on the keyboard to enter into “ Partial Arm ” mode. Press F2 to
enter into enter into “ Full Arm ” mode. Note: You can switch from “ Full Arm ” mode
to “ Partial Arm ” mode by disarming the alarm host and then pressing F1 key. To
disarm the alarm host, please press F3 key and then enter the correct user password.