User manual

28
2. Modify Alarm Mode and Arm/Disarm in SET Mode
Enter # # # A A A A A A # to enter into set-up mode and modify alarm mode.
① Arm the host in phone alarm mode
Enter 1 # to arm in phone alarm mode and exit set-up mode.
② Arm in on-site alarm mode
Enter 3 # to arm in on-site alarm mode and exit set-up mode.
“ A A A A A A ” refers to a 6-digit set-up password. The factory default set-up
password is “ 112233 ” . Once arm is completed, the host will automatically exit
set-up mode and is under leaving state. If leaving time is not set up, the host will
enter into arm mode immediately, and the indicator for the corresponding defense
zone and “ ARM ” indicator will light up.
③
Disarm
Enter 2 # , and then the host will automatically disarm.
This disarm operation does not cause detector alarm information and failure
information to be deleted.
Once the above mentioned arm/disarm operation is completed, the system will
automatically exit set-up mode.
3: Arm/Disarm by Remote Control
Press the “ Full Arm ” key on the remote control, and then your alarm host will
indicate through voice prompts that you are entering into full arm mode.
Press the “ Partial Arm ” key on the remote control, and then your alarm host
will indicate through voice prompts that you are entering into partial arm mode.
Press the “ Disarm ” key on the remote control, and then your alarm host will
indicate through voice prompts that the host is being disarmed.
4: Remote arm/disarm by fixed phone or mobile phone
Please refer to relevant operation procedures in “ Alarm Receiving Operation ”
and “ Remote Set-up ” .
2.
2.
2.
2. Alarm
Alarm
Alarm
Alarm Operation
Operation
Operation
Operation
Anti-theft Operation:
Before you leave your residence or work place, please follow any of