User manual

3
zone) in which the host can receive shielded signals, and can not receive any alarm
signal temporarily.
Full
Full
Full
Full Arm
Arm
Arm
Arm It refers to the state in which all alarm detectors in full arming zone or
part arming zone enter into alert state.
Partial
Partial
Partial
Partial Arm
Arm
Arm
Arm It refers to the state in which all alarm detectors in part arming zone
enter into alert state.
User
User
User
User Password
Password
Password
Password It refers to the password through which user can arm/disarm
zones.
Set-up
Set-up
Set-up
Set-up Password
Password
Password
Password It refers to the password used for user set-up.
Entry
Entry
Entry
Entry Time
Time
Time
Time After receiving alarm information, user alarm host does not alarm
immediately, and after a period of time, it will alarm. This period of time is called
entry time or delayed alarm time.
Leaving
Leaving
Leaving
Leaving Time
Time
Time
Time After receiving arming command, user alarm host does not enter into
arming mode immediately, and after a period of time, it will enter into arming mode.
This period of time is called leaving time or delayed arming time.
Ringing
Ringing
Ringing
Ringing Times
Times
Times
Times It refers to times of ringing the phone when users dial a fixed
phone number or SIM card number connected to the host for remote set-up.
Dialling
Dialling
Dialling
Dialling Times
Times
Times
Times It refers to times of dialling preset user phone numbers when the
host gives out an alarm in fixed phone alarm mode or mobile phone alarm mode.
Siren
Siren
Siren
Siren Duration
Duration
Duration
Duration After triggering on-the-spot alarm, the alarm host begins to
count immediately. Once the preset period of time expires, the alarm host will stop
alarming, and terminate transmitting alarm output signal. This preset period of time
is called siren duration.
Phone
Phone
Phone
Phone Alarm
Alarm
Alarm
Alarm Mode
Mode
Mode
Mode It refers to the mode in which user alarm host can
automatically dial pre-set informed telephone numbers when an alarm occurs, users
can arm/disarm the host through the alarm receiving phone, and the alarm host can
automatically check whether phone line is cut off.
On-site
On-site
On-site
On-site Alarm
Alarm
Alarm
Alarm Mode
Mode
Mode
Mode It refers to the mode in which user alarm host can neither
automatically dial alarm phones nor check if phone line is cut off, but can alarm on
the spot.