User manual

8
minute.
15) “ Emergency Zone ” Indicator: “ Emergency Zone ” Indicator will light up only when
set-up is performed for an emergency zone. Once emergency zone set-up is
completed, the indicator is not turned on even when an alarm occurs.
16) “ Doorbell Zone ” Indicator: “ Doorbell Zone ” Indicator will light up when set-up is
performed for a doorbell zone. Once doorbell zone set-up is completed, the indicator
is not turned on even when an alarm occurs.
17) 0~9 Number Key: 0~9 Number Key is used to enter parameters and password
when the alarm host is under set-up mode or signal learning mode.
18) #
#
#
# ： “ #
#
#
# ” key acts as “ ENTER ” key or is used for confirmation.
19) *
*
*
* :
:
:
: Set attribute of defense zone
20) F1 Key: F1 key acts as
“
Partial Arm
”
key. Press F1 key to enter into
“
Partial Arm
”
mode. Note: If the host is under “ Full Arm ” mode, disarm the host and then press F1
key to enter into “ Partial Arm ” mode.
21) F2 Key: F2 key acts as “ Full Arm ” key. Press F2 key to enter into “ Full Arm ” mode.
22) F3 Key: F3 key acts as “ Disarm ” key. Press F3 key, and then the host will give the
prompt “ P lease enter user password ” . Enter correct user password and then enter
“
#
”
key to enter into disarm mode.
23) F4 Key :
:
:
: F4 key acts as “ Emergency Alarm ” key. Press F4 key to trigger an alarm.
24) A, B, C Key: The functions of A and C keys are not defined temporarily. B key is
used for set-up of linkage module manufactured by our support company.
2
2
2
2 、 Installation
Installation
Installation
Installation &
&
&
& Wiring
Wiring
Wiring
Wiring Diagram
Diagram
Diagram
Diagram of
of
of
of Engineering
Engineering
Engineering
Engineering Host
Host
Host
Host (See
(See
(See
(See
the
the
the
the Diagram
Diagram
Diagram
Diagram Below)
Below)
Below)
Below)