Instruction Manual

Harness System Adjustments
for Smaller Infants
15
continued on next page
16
With Buckle in the 1st Slot As
Shown, Turn Car Seat Over
If you need to move the buckle
to the 1st slot, see pages 13-14.
Release Pad’s Elastic Straps
Off of Tabs
From Top of Car Seat,
Lift Pad off Front of Shell
2
1
sewn
end
1
2
From Back of Car Seat,
Remove Harness Strap
Loops From Splitter Plate
Attach 2nd Harness Strap Loops
to Splitter Plate As Shown
The sewn ends of the harness strap
loops must face towards you.
Do not twist the harness strap or the
harness adjustment strap.
Make sure the same harness strap
loops are fitted completely on both
sides of the splitter plate.
The harness strap loop ends must go
through the recline stand as shown.
The harness adjustment strap must lie
under the harness strap as shown.
Check your child’s fit often.
To learn how to check harness
tightness, see pages 48-50.
If you cannot achieve a snug harness fi t for your child,
you may need to adjust the harness strap and/or buckle
strap length as shown in this section.
Adjusting Harness Strap
Adjusting Buckle Strap
Recline Stand
Harness Adjustment
Strap
3