Instruction Manual

57 58
sewn
end
6
7
Attach 1st Harness Strap Loops
to Splitter Plate As Shown
The sewn ends of the harness strap
loops must face towards you.
Do not twist the harness strap or the
harness adjustment strap.
Make sure the same harness strap
loops are fitted completely on both
sides of the splitter plate.
The harness strap loop ends must
go through the recline stand as
shown.
The harness adjustment strap must lie
under the harness strap as shown.
5
4
From Back of Car Seat,
Pull Harness Strap
Through Pad and Shell
Do not twist the harness strap.
Thread Buckle and Chest Clip
The harness strap ends go through
the back of the buckle tongues and
through the chest clip front to back
as shown.
Thread Harness Straps
into Correct Shoulder
Harness Slots for Your Child
For Rear-Facing child fi t, see page 8.
For Forward-Facing child fi t, see page 9.
Recline Stand
Harness Adjustment
Strap
Check your child’s fit often.
If you cannot achieve a snug harness fit for your child,
see pages 15-17.
To learn how to check harness tightness, see pages 48-50.
Check the harness straps often for any wear or damage.
The harness system must be installed correctly. Do not
use a child restraint with damaged harness straps.