Brochure

REMOVABLE FLOOR MOUNT
REMOVABLE FACE MOUNT
This floor mounted guardrail system has
three versions of floor mounted railing
holder. A single post receiver acts as the
first and last piece of a typical safety
railing installation. The double post
receiver acts as the intermediate receiver
for in-line railing runs. And finally, the
corner post receiver allows the railing to be
turned at 90 degree increments.
Optional fold-down
railings allow easy
access when needed.
Railing lengths available
from 2’ to 10’
SAFETY RAIL COMPANY LLC.
|
4244 SHORELINE DRIVE - PO BOX 427 SPRING PARK, MN 55384
|
888-434-2720
|
WWW.SAFETYRAILCOMPANY.COM
The only drawback to permanent railings can be that every so often they are in the way of areas you need to access - that is until now. Safety Rail
Company offers permanent mounted guardrail with the ability to simply lift the railing out of the railing holder thereby freeing up access between
the floor mounts. You get the best of both worlds. Fall protection when you need it and free and clear spaces when required. With a number of
railing mount options to choose from, you are sure to find the best solution to your job specific requirements. Toeboards available for all models.
REMOVABLE GUARDRAIL SYSTEMS
Our Face Mount Removable Guardrail
systems allow railings to be mounted to
the vertical wall of a pit or hole thereby
eliminating floor mounted railing holders.
Railings can be removed for complete
access when required.
This face mounted guardrail system has
two versions of wall mounted railing holder.
A single post receiver acts as the first and last piece of a safety railing installation.
The double post receiver acts as the intermediate receiver for in-line railing runs.
Railings lift out for side access
to flatbeds in shipping pits.
REMOVABLE FLUSH MOUNT
Our Flush Mount Removable Guardrail
systems are another great solution to
providing fall protection around pits or holes
where having a railing holder standing above
the floor is not an option.
This mount wraps over the edge of a pit or
wall. Many times shipping pits will have a
3” angle iron embedded into the concrete to
protect the edge.
This mount wraps over the top
of the angle iron allowing it to
be drilled into the floor behind
the angle iron and then to the
face of the pit. A single post
mount acts as the first and last
railing holder and the double
post mounts act as the
intermediate railing holders.
Railings stand 42” above walking
surface when mounted at top edge.
SINGLE POST
FACE MOUNT - 400036
DOUBLE POST
FACE MOUNT - 400016
DOUBLE POST
FLUSH MOUNT - 400028
CORNER POST
FLOOR MOUNT - 400037
DOUBLE POST
FLOOR MOUNT - 400035
SINGLE POST
FLUSH MOUNT - 400055
SINGLE POST
FLOOR MOUNT - 400033