User's Manual

Installation and Operation Manual

STI Universal Sensor

Model: STI-34401

Thank you for purchasing this fine product. We want you to know that your satisfaction

is very important to us. We suggest you take the time to read this manual carefully to get

the most from your new product.

HOW THE PRODUCT WORKS

The STI Universal Sensor has a reed switch, tilt switch and terminals for an external

switch input read by STI receivers as the 3 different “Sensor Configuration"

transmissions. Jumper wires must be configured for the appropriate sensor application

(door sensor, mailbox alert, garage door sentry, etc).

Sensor Configurations (MAGNETIC, TILT, EXTERNAL):

The Magnetic Sensor, Tilt Sensor and External Terminals each have their own Sensor

Configuration, and each STI Universal Sensor has its own ID number to ensure there is

no duplication of wireless signals to an STI receiver. To allow multiple Universal

Sensors with the same Sensor Configuration, STI receivers interpret each Sensor

Configuration and ID number pair as a separate and unique input signal.

The U-Sensor transmits only a single Sensor Configuration (MAGNETIC, TILT, or

EXTERNAL) depending upon how the jumper wires are configured. The sensor will not

react to other device changes if the jumper configuration is not set. For example, the

magnetic sensor open and close changes will not be transmitted in the wireless message if

the sensor is configured as a TILT SENSOR type.

Jumper Configurations:

PAGE 1
Installation and Operation Manual STI Universal Sensor Model: STI-34401 Thank you for purchasing this fine product. We want you to know that your satisfaction is very important to us. We suggest you take the time to read this manual carefully to get the most from your new product. HOW THE PRODUCT WORKS The STI Universal Sensor has a reed switch, tilt switch and terminals for an external switch input read by STI receivers as the 3 different “Sensor Configuration" transmissions.
PAGE 2
Installation and Operation Manual STI Universal Sensor Model: STI-34401 U-Sensor Setup: 1. Open device using a flat head screwdriver in the slot under the case. 2. Configure the jumpers for the desired application. (See Jumper Configuration) 3. Insert 3V lithium 123A size battery in the proper orientation. 4. Program the STI Universal Sensor into the STI receiver. NOTE: Please refer to the STI receiver installation instructions for this. 5.
PAGE 3
Installation and Operation Manual STI Universal Sensor Model: STI-34401 Operation: Magnetic Sensor: • Alert Signal – Magnet is over 1-1/2” from the “►“ shape. (typically) • Restore Signal – Magnet is brought within 1-1/4” from the “►“ shape. (typically) Tilt Sensor: • Alert Signal – Sensor is tilted more than 45° from vertical. • Restore Signal – Sensor is tilted less than 45° from vertical. Ext.