Specifications

PARAMETER 2
2-103
Classification
USER
Display title
LINE/FACE/3D
Address Meaning Description
Tool-path pattern selection for line
machining unit
Program type M
Conditions Immediate
E95
Unit Bit
Setting range Binary, eight digits
For the 2nd and subsequent rounds of cutting:
0: Not via the approach point
1: Via the approach point
For the 2nd and subsequent rounds of cutting:
0: Escape to the Z-axis initial point
1: No escape on the Z-axis
1: Rapid feed up to the intended surface +
E9
1: Escape is set to a point where the tool comes
out of the removal allowance.
The R-point height for central, right hand, left
hand, outside and inside linear machining is:
0: Set always to
E9
1: Set to E7 or E9 when there is or isn’t pre-
machining in the same unit, respectively.
The X-Y plane clearance for outside and inside
linear machining is:
0: Set always to
E2
1: Set to E5 or E2 when there is or isn’t pre-
machining in the same unit, respectively.
- Bit 2
MPL501
Initial point
1st removal allowance
2nd removal allowance
Bit 2 = 0Bit 2 = 1
Approach point Cutting start point
- Bit 3
Bit 3 = 0
Bit 3 = 1
Initial point
1st removal allowance
2nd removal allowance
Approach point Escape point
MPL502
- Bit 5
E2
E2
Escape point
MPL503
WID-R
Bit 5 = 1Bit 5 = 0
Note:
Bit 3 valid only for inside/outside line machining unit.
7 6 5 4 3 2 1 0
Return to Library