Specifications

2 PARAMETER
2-104
Classification
USER
Display title
LINE/FACE/3D
Address Meaning Description
Tool-path pattern selection for end milling-
slot unit
Program type M
Conditions Immediate
E96
Unit Bit
Setting range Binary, eight digits
7 6 5 4 3 2 1 0
0: The R-point height is set always to E9.
1: The R-point height is set to
E7 or E9 when
there is or isn’t pre-machining in the same
unit, respectively.
For the 2nd and subsequent rounds of cutting:
0: Not via the approach point
1: Via the approach point
1: Rapid feed up to the intended surface +
E9
Returning feed rate override of the end milling-
slot unit
0: Invalid
1: Valid
Tool-path pattern selection for end milling-
top unit
Program type M
Conditions Immediate
E97
Unit Bit
Setting range Binary, eight digits
0: The R-point height is set always to
E9
1: The R-point height is set to E7 or E9 when
there is or isn’t pre-machining in the same
unit, respectively.
1: Rapid feed up to the intended surface +
E9
Cutting method selection for end milling-
mountain, pocket milling-valley unit
Program type M
Conditions Immediate
E98
Unit Bit
Setting range Binary, eight digits
7 6 5 4 3 2 1 0
1: The 1st cutting amount exceeds the
command value at end milling-mountain or
pocket valley-machining.
—
Program type M
Conditions Immediate
E99
Unit Bit
Setting range Binary, eight digits
Milling feed rate specification range for the
shape sequence of the MAZATROL program
0: Valid for roughing
1: Valid for finishing
Bottom/wall simultaneous finishing mode for
pocket machining
0: Sequential (Conventional scheme)
1: Simultaneous
7 6 5 4 3 2 1 0
7 6 5 4 3 2 1 0
Return to Library