Specifications

PARAMETER 2
2-127
Classification
USER
Display title
EIA/ISO
Address Meaning Description
—
Program type M, E
Conditions At power on
F91
Unit Bit
Setting range Binary, eight digits
In response to move command without decimal
point:
0: Tool moves by 1/1.
1: Tool moves by 10/1.
Coordinate system shift using a MAZATROL
program:
0: Invalid
1: Valid
0: Stroke inside check before movement
1: Stroke outside check before movement
0: Metric (Initial G20 is valid/invalid)
1: Inch
In response to move command without decimal
point:
0: Tool moves in 0.0001 mm (0.00001 inch)
increments.
1: Tool moves in 1 mm (1 inch) increments.
0: G00 interpolation
1: G00 non-interpolation
0: G33E command is for the number of threads
per inch
1: G33E command is for thread cutting with
precise lead
Note:
For changing bit 4 (millimeter/inch system), set M18 bit 7 to 0 once for
zero point return execution if the simplified software OT function is
effective (when machine parameter
M18 bit 7 = 1, R2 bit 7 = 0).
(This initialization is required when the simplified OT function is effective
even for one axis.)
—
Program type M, E
Conditions At power on
F92
Unit Bit
Setting range Binary, eight digits
Modal at power-on or at reset (Initial G18)
0: G17 or G19
1: G18
Modal at power-on or at reset (Initial G19)
0: G17 or G18
1: G19
Fixed value (0), Dwell command always in time
Tool-length compensation (G43 or G44) axis
0: Program command axis
1: Z-axis fixed
Tool-diameter compensation (G41 or G42) start
up/cancel type
0: Type A
1: Type B
Tool-diameter compensation (G41 or G42)
interference check
0: Alarm stop occurs to prevent overcutting.
1: Tool path is changed to prevent overcutting.
Fixed-cycle hole-drilling axis
0: Plane selection using G17, G18 or G19
1: Z-axis fixed
Tool diameter compensation for an EIA/ISO
program
0: Tool offset fixed
1: Tool data valid
7 6 5 4 3 2 1 0
7 6 5 4 3 2 1 0
Return to Library