Specifications

2 PARAMETER
2-150
Classification
USER
Display title
EIA/ISO
Address Meaning Description
—
Program type M
Conditions After stop of movement
F165
Unit Bit
Setting range Binary, eight digits
High-speed synchronous tapping function
0: Valid
1: Invalid
X-axis movement to minus side during polar
coordinate interpolation
0: Enabled
1: Disabled
C-axis indexing when EIA subprogram is called
from MAZATROL program
0: Not executed
1: Executed
Modal or non-modal state of Q command in deep
hole drilling cycle
0: Modal
1: Non-modal
Conversion of tool set data for milling tool based on
head swivel angle when G53.5 is commanded
0: Disabled
1: Enabled
Behavior of automatic operation of an EIA program
when Z-offset is not set
0: Z-offset = 0
1: Alarm stop
Setting at CONTI. of the END unit during tool path
check
0: Invalid
1: Valid
Supplemental explanation of F165 Bit 4
This bit is used to select whether the depth of infeed per pass (address Q
command) in deep hole drilling cycles (G83, G283, and G287 for G-code
series M; G83 and G87 for G-code series A) is modal or non-modal.
0: Modal
The modal value is used if the Q command is not specified. If the
modal value of the Q command is 0 (typically, in cases where the Q
setting is omitted in the initial deep hole drilling cycle command), or if
the Q value is set to 0, an alarm ILLEGAL NUMBER INPUT occurs.
1: Non-modal
If the Q setting is omitted, or if the Q value is set to 0, the workpiece is
cut to the preset infeed depth in a single pass.
7 6 5 4 3 2 1 0
Return to Library